Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291898 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (USING SST (CHECK WIRE))


a.
H103023E06
1.927,1.896 1.76,1.469 true 1.615,0.896 0.854,0.406 true 0.604,0.281 1.198,0.635 0.594,0.354 10 false CG 1.979,1.906 2.521,2.177 0.542,0.271 10 false TC

Check the DTCs (Present trouble code).

i.

Turn the ignition switch on (IG), and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals to the correct positions to avoid a malfunction.




b.

Check the DTCs (Past trouble code).

i.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals to the correct positions to avoid a malfunction.



ii.

Turn the ignition switch on (IG), and wait for approximately 60 seconds.



c.

Read the DTCs.

H103114E01
0.198,0.25 2.052,0.646 1.854,0.396 10 false Normal System Code (without Past Trouble Code) 2.635,0.25 4.302,0.615 1.667,0.365 10 false Normal System Code (with Past Trouble Code) 4.99,0.25 7.042,0.563 2.052,0.313 10 false DTC (Example DTCs 11 and 31) 0.646,1.031 1.313,1.271 0.667,0.24 10 false 0.25 sec. 3.188,1.042 3.917,1.292 0.729,0.25 10 false 0.75 sec. 5.354,0.833 5.917,1.083 0.563,0.25 10 false 2.5 sec. 6.125,0.844 6.719,1.094 0.594,0.25 10 false 4.0 sec. 5.031,1.635 5.615,1.875 0.583,0.24 10 false 1.5 sec. 5.083,1.927 5.75,2.135 0.667,0.208 10 false DTC 11 6.604,1.656 7.083,1.896 0.479,0.24 10 false Repeat 0.292,1.885 0.958,2.125 0.667,0.24 10 false 0.25 sec. 2.865,1.865 3.531,2.104 0.667,0.24 10 false 0.25 sec. 4.781,0.823 5.365,1.094 0.583,0.271 10 false 0.5 sec. 5.615,1.635 6.198,1.906 0.583,0.271 10 false 0.5 sec. 5.75,1.927 6.417,2.135 0.667,0.208 10 false DTC 31

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and DTCs 11 and 31 are shown in the illustration to the left.

·

Normal system code indication (without past trouble code):

The light blinks twice per second.

·

Normal system code indication (with past trouble code):

When the past trouble code is stored in the center airbag sensor, the light blinks only once per second.

·

Trouble code indication:

The first blinking indicates the first DTC. The second blinking occurs after a 1.5 second pause.


If there are more than 1 code, there will be a 2.5 second pause between each code. After all codes are shown, there will be a 4.0 second pause, and they all will be repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller numbered code.

·

If DTCs are indicated without connecting the terminals, proceed to the "TC and CG Terminal Circuit" procedure (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>TC and CG Terminal Circuit).






CLEAR DTC (USING SST (CHECK WIRE))


a.

Clear the DTCs.

i.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next procedure.



ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch on (IG).

SST
09843-18040  


iii.

Disconnect terminal 13 (TC) of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.


iv.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.


v.

The SRS warning light should go off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13(TC) within 2 to 4 seconds after the SRS warning light goes off.


vi.

The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13(TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.


vii.

Check if the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

C109537E51
0.052,0.625 1.031,0.833 0.979,0.208 10 false Ignition Switch 0.052,1.354 1.313,1.573 1.26,0.219 10 false DLC3 (TC and CG) 0.052,1.885 1.479,2.115 1.427,0.229 10 false SRS Warning Light (*) 3.052,1.677 3.802,1.885 0.75,0.208 10 false 0.5 sec. 5.625,1.667 6.385,1.875 0.76,0.208 10 true 0.25 sec. 0.323,2.26 1.375,2.479 1.052,0.219 10 false T1: 0 to ∞ sec. 0.323,2.573 1.49,2.771 1.167,0.198 10 false T2: approx. 6 sec. 0.323,2.875 1.302,3.083 0.979,0.208 10 false T3: 3 to 5 sec. 0.323,3.208 1.344,3.417 1.021,0.208 10 false T4: 3 to 10 sec. 0.323,3.5 1.26,3.708 0.938,0.208 10 false T5: 2 to 4 sec. 0.323,3.833 1.26,4.052 0.938,0.219 10 false T6: 1 to 5 sec. 0.323,4.177 1.406,4.375 1.083,0.198 10 false T7: within 1 sec. 2.271,4.25 6.792,4.531 4.521,0.281 10 false *: The past trouble code in the illustration shows DTC 21 as an example. 2.458,3.313 2.99,3.542 0.531,0.229 10 false T1 5.948,3.292 6.479,3.521 0.531,0.229 10 false T7 4.417,3.292 4.948,3.521 0.531,0.229 10 false T6 4.167,3.292 4.698,3.521 0.531,0.229 10 false T5 3.719,3.302 4.25,3.531 0.531,0.229 10 false T4 3.24,3.302 3.771,3.531 0.531,0.229 10 false T3 2.844,3.302 3.375,3.531 0.531,0.229 10 false T2 4.938,3.292 5.469,3.521 0.531,0.229 10 false T6 4.677,3.292 5.208,3.521 0.531,0.229 10 false T5 5.448,3.302 5.979,3.531 0.531,0.229 10 false T6 5.198,3.302 5.729,3.531 0.531,0.229 10 false T5 5.719,3.302 6.25,3.531 0.531,0.229 10 false T5 6.25,1.667 6.99,1.875 0.74,0.208 10 true 0.25 sec. 3.615,1.677 4.365,1.885 0.75,0.208 10 false 0.5 sec. 1.74,0.406 2.229,0.604 0.49,0.198 10 false on (IG) 1.74,0.854 2.208,1.073 0.469,0.219 10 false off 1.74,1.531 2.125,1.771 0.385,0.24 10 false Short 1.74,1.177 2.146,1.417 0.406,0.24 10 false Open 1.74,1.917 2.01,2.125 0.271,0.208 10 false ON 1.74,2.281 2.052,2.49 0.313,0.208 10 false OFF 3.604,2.635 4.354,2.844 0.75,0.208 10 false 1.5 sec.




CHECK DTC (USING INTELLIGENT TESTER)


a.
B135940E03
1.834,1.735 1.701,2.029 false 1.474,2.037 1.869,2.207 0.396,0.170 10 DLC3 0.505,2.789 1.573,2.954 1.068,0.165 10 Intelligent Tester 0.598,2.61 0.598,2.792 false

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Check the DTCs by following the prompts on the tester screen.

HINT:

Refer to the intelligent tester operator's manual for further details.




CLEAR DTC (USING INTELLIGENT TESTER)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Clear the DTCs by following the prompts on the tester screen.

HINT:

Refer to the intelligent tester operator's manual for further details.