Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291898 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1000/31  Center Airbag Sensor Assembly Malfunction  


DESCRIPTION

The center airbag sensor consists of the airbag sensor, the safing sensor, the drive circuit, the diagnosis circuit and the ignition control.

If the center airbag sensor receives signals from the airbag sensor, it determines whether or not the SRS should be activated.

DTC B1000/31 is recorded when a malfunction is detected in the center airbag sensor.

DTC No. DTC Detection Condition Trouble Area
B1000/31 Center airbag sensor malfunction Center airbag sensor

HINT:

When a malfunction code is displayed simultaneously with DTC B1000/31, repair the malfunction indicated by this code (except DTC B1000/31) first.


PROCEDURE

1.CHECK CENTER AIRBAG SENSOR ASSEMBLY
H041086E20
0.656,1.01 0.5,1.438 true 0.75,1.219 0.896,1.427 true 0.51,0.521 0.958,0.719 0.448,0.198 10 false DLC3 0.333,1.458 0.625,1.656 0.292,0.198 10 false CG 0.792,1.458 1.031,1.656 0.24,0.198 10 false TC 2.313,0.531 2.917,0.729 0.604,0.198 10 false DTC 31

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


d.

Turn the ignition switch on (IG), and wait for at least 60 seconds.



f.

Turn the ignition switch off.


g.

Turn the ignition switch on (IG), and wait for at least 60 seconds.


h.

Check the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B1000/31 is not output.




OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE CENTER AIRBAG SENSOR ASSEMBLY