Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291898 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1630/23  Driver Side Rear Airbag Sensor Malfunction  


DESCRIPTION

The rear airbag sensor (for driver side) consists of parts including the diagnostic circuit and the lateral deceleration sensor.

When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.

DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor (for driver side).

DTC No. DTC Detection Condition Trouble Area
B1630/23 When one of following conditions is met:
·

Rear airbag sensor (for driver side) malfunction

·

Center airbag sensor malfunction


·

Rear airbag sensor LH (for LHD)

·

Rear airbag sensor RH (for RHD)

·

Center airbag sensor



PROCEDURE

1.CHECK REAR AIRBAG SENSOR (for Driver Side)
C135334E03
1.688,0.438 1.688,0.24 1.688,0.24 2.01,0.24 false 0.729,4.073 0.885,3.667 true 1.167,4.073 0.969,3.865 true 1.708,2.031 3.083,2.219 1.375,0.188 10 false Center Airbag Sensor 2.063,0.042 3.156,0.635 1.094,0.594 10 false Rear Airbag Sensor (for Front Passenger Side) 0.063,1.906 1.354,2.51 1.292,0.604 10 false Driver Side - Side Airbag Sensor (for Front Side) 0.708,3.333 1.125,3.5 0.417,0.167 10 false DLC3 0.49,4.063 0.729,4.229 0.24,0.167 10 false CG 1.146,4.063 1.385,4.229 0.24,0.167 10 false TC 2.198,2.563 2.698,2.708 0.5,0.146 10 false DTC 23 2.198,3.563 2.698,3.708 0.5,0.146 10 false DTC 24

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the rear airbag sensor (for driver side) with the rear airbag sensor (for front passenger side) and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch on (IG), and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch on (IG), and wait for at least 60 seconds.


i.

Check the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC B1630/23 and B1635/24 are not output A
DTC B1630/23 is output B
DTC B1635/24 is output C

HINT:

DTCs other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.




A

USE SIMULATION METHOD TO CHECK

B

REPLACE CENTER AIRBAG SENSOR ASSEMBLY

C

REPLACE REAR AIRBAG SENSOR (for Driver Side)