The rear airbag sensor (for front passenger side) consists of parts including the diagnostic circuit and the lateral deceleration sensor.
When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1635/24 is recorded when a malfunction is detected in the side rear airbag sensor (for front passenger side).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1635/24 | When one of following conditions is met:
·
Rear airbag sensor (for front passenger side) malfunction ·
Center airbag sensor malfunction |
·
Rear airbag sensor RH (for LHD) ·
Rear airbag sensor LH (for RHD) ·
Center airbag sensor |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the rear airbag sensor (for front passenger side) with the rear airbag sensor (for driver side) and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1630/23 and B1635/24 are not output | A |
| DTC B1635/24 is output | B |
| DTC B1630/23 is output | C |
DTCs other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.
A
B
C