The rear floor airbag sensor consists of parts including the diagnostic circuit and the lateral deceleration sensor.
When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1675/18 is set when a malfunction is detected in the rear floor airbag sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1675/18 | When one of following conditions is met:
·
Rear floor airbag sensor malfunction ·
Center airbag sensor malfunction |
·
Rear floor airbag sensor ·
Center airbag sensor |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the rear floor airbag sensor with the center floor airbag sensor and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1665/17 and B1675/18 are not output. | A |
| DTC B1675/18 is output. | B |
| DTC B1665/17 is output. | C |
DTCs other than DTC B1665/17 and B1675/18 may be output at this time, but they are not related to this check.
A
B
C