Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291899 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 45186 2.REMOVE NO. 2 STEERING WHEEL LOWER COVER

a.
C139023

Detach the 2 claws and remove the cover.


Hide 45187 3.REMOVE NO. 3 STEERING WHEEL LOWER COVER

a.

Use the same procedures for the No. 2 steering wheel lower cover and No. 3 steering wheel lower cover.


Hide 45130 4.REMOVE STEERING PAD ASSEMBLY

C136809E02
1.26,0.615 1.26,1.063 true 1.26,1.052 1.365,1.052 true 1.396,0.969 2.208,1.313 0.813,0.344 10 true Screw Case

a.

Straighten the front wheels.


b.

Using a T30 "TORX" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.


c.
C136810

Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



d.

Using a screwdriver, disconnect the airbag connector.

CAUTION:

When handling the airbag connector, do not damage the airbag wire harness.



e.

Disconnect the horn connector and remove the steering pad.