1.CHECK REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION AND AIRBAG NOT DEPLOYED)
Perform a diagnostic system check (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
2.CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG NOT DEPLOYED)
Perform a diagnostic system check (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
If the quarter panel of the vehicle or its periphery are damaged, perform a visual check:
Check for cracks, dents or chips in the case.
Check for cracks, dents, chips and scratches in the connector.
Check for peeling off of the label or damage to the serial number.
If any of the defects mentioned above are present, replace the rear airbag sensor with a new one.
For removal and installation procedures of the rear airbag sensor, be sure to following the correct procedures.
3.CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG DEPLOYED)
Replace the rear airbag sensor.
For removal and installation procedures of the rear airbag sensor, be sure to follow the correct procedures.
If the airbags have deployed, replace the side airbag sensor on the side in which the collision occurred. Replace both if necessary.