Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD(for RHD) › from 2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291912 STEERING PAD(for RHD) A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45187 3.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B369930E01
2.01,0.73 1.677,0.396 1.677,0.396 1.473,0.396 false 1.257,0.304 1.444,0.479 0.187,0.176 10 *a

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 3 steering wheel cover.

Text in Illustration
*a Protective Tape


Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B369931E01
1.607,0.756 1.939,0.423 1.939,0.423 2.136,0.423 false 2.155,0.332 2.332,0.515 0.177,0.183 10 *a

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 2 steering wheel cover.

Text in Illustration
*a Protective Tape


Hide 45130 5.REMOVE STEERING PAD ASSEMBLY

CAUTION:

When storing the steering pad assembly, keep the airbag deployment side facing upward.


a.

Check that the engine switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B434331E02
0.396,0.427 0.677,0.427 true 0.688,2.781 0.688,2.542 true 2.917,2.594 2.635,2.594 true 0.198,0.333 0.375,0.51 0.177,0.177 10 false *a 0.615,2.823 0.792,3 0.177,0.177 10 true *a 2.938,2.51 3.094,2.677 0.156,0.167 10 true *a

Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins.

Text in Illustration
*a Torsion Spring

NOTICE:

Do not drop the steering pad assembly.


HINT:

Insert the screwdriver from the installation holes for the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover.



d.

Pull out the steering pad assembly from the steering wheel assembly and support the steering pad assembly with one hand.

NOTICE:

When separating the steering pad assembly, do not pull the airbag wire harness.



e.
B381102E03
1.406,1.813 2.438,1.813 true 1.24,2.021 1.25,2.49 1.25,2.49 2.417,2.49 true 1.969,2.094 2.083,1.948 2.083,1.948 2.615,1.948 true 0.802,0.615 1.094,0.938 1.094,0.938 1.375,0.938 true 2.458,1.708 2.635,1.917 0.177,0.208 10 true *a 2.458,2.417 2.771,2.573 0.313,0.156 10 false *b 2.667,1.875 2.885,2.083 0.219,0.208 10 true *c 1.417,0.875 1.729,1.031 0.313,0.156 10 false *d

Disconnect the horn connector from the steering pad assembly.


f.

Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.

Text in Illustration
*a Protective Tape
*b Airbag Connector
*c Horn Connector
*d Airbag Connector Lock


g.

Disconnect the airbag connector to remove the steering pad assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.