Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059563 SEAT BELT _0291916 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (see page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 73200A 1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B145406

a.

Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

NOTICE:

Do not disassemble the retractor.


a.
U188802

Align the 2 claws with the seat belt positioning holes, and install the retractor of the outer belt with the 2 bolts as shown in the illustration.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

for upper bolt

42 N*m (428 kgf*cm, 31 ft.*lbf)

for lower bolt



b.
B145344

Connect the pretensioner connector as shown in the illustration.


c.

w/ Pre-crash safety system:

Connect the pre-crash seat belt connector.


d.
B122779

Connect the outer belt with the shoulder anchor's bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 62412 3.INSTALL CENTER PILLAR GARNISH LH

B139954

a.

Pass the outer belt anchor through the center pillar garnish.


b.

Attach the clip.


c.

Install the garnish with the 2 screws.


Hide 74603C 4.INSTALL ASSIST GRIP SUB-ASSEMBLY

Hide 74617A 5.INSTALL ASSIST GRIP PLUG

Hide 62414A 6.INSTALL CENTER PILLAR GARNISH LOWER LH

B136652

a.

Attach the 2 claws and 2 clips to install the garnish.


b.

Connect the floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73233 7.INSTALL LAP BELT OUTER ANCHOR COVER

B104264

a.

Install the cover.


Hide 62332C 8.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67918E 9.INSTALL REAR DOOR SCUFF PLATE LH

Hide 67914B 10.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 62312B 11.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 28800 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 28800 13.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.