Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
67914B
2.REMOVE FRONT DOOR SCUFF PLATE LH
67918E
3.REMOVE REAR DOOR SCUFF PLATE LH
67918D
4.REMOVE REAR DOOR SCUFF PLATE LH
62312B
5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62331C
6.REMOVE NO. 1 SLIDE DOOR WEATHERSTRIP
73233
7.REMOVE LAP BELT OUTER ANCHOR COVER
Remove the lap belt outer anchor cover.
62414A
8.REMOVE CENTER PILLAR GARNISH LOWER LH
Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.
Using a screwdriver, detach the 2 claws and remove the garnish.
Tape the screwdriver tip before use.
74617A
9.REMOVE ASSIST GRIP PLUG
74603C
10.REMOVE ASSIST GRIP SUB-ASSEMBLY
62412
11.REMOVE CENTER PILLAR GARNISH LH
Using a clip remover, detach the clip.
Detach the claw and remove the garnish.
73220
12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Remove the nut and disconnect the shoulder anchor.
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and front seat outer belt assembly LH.
73200A
13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts and anchor.