NOTICE FOR INITIALIZATION
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System | See procedure |
|---|---|
| Lighting System (w/ AFS) | ( )
|
| Parking Assist Monitor System | |
| Power Slide Door System | |
| Power Back Door System |
HANDLING PRECAUTIONS FOR HID HEADLIGHT
When any defect such as deformation, cracks, dents, chipping, etc. is identified on the HID headlight, replace it with a new one.
Even if the operation seems to be normal, the fail-safe function may be defective.
Since bulbs of the HID headlight and halogen bulbs (for headlight and fog light) have pressurized gas inside and can easily be broken if scratched or dropped, special care should be taken. When handling the bulb, hold the plastic or metal part and do not touch the glass part with bare hands.
Never touch the high voltage socket of the HID headlight with the headlight dimmer switch ON, as this could generate 20,000 V and lead to a serious accident.
Never connect a tester to the high voltage socket of the HID headlight for measurement, as this may lead to a serious accident because of high voltage.
When performing operations related to the HID headlight, keep it away from water such as rain, turn off the headlight dimmer switch, and disconnect the cable from the negative (-) battery terminal and the connector of the headlight (Lo) in advance to avoid electric shock.
When performing operations related to the HID headlight, operate it after assembling has been finished and never operate it without a bulb installed.
Only illuminate the discharge headlight using the vehicle's power source.
PRECAUTIONS FOR HEADLIGHT BULB REPLACEMENT
If even a thin film of oil is left on the surface of the HID headlight bulb or halogen bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand will not contact the glass part of the light.
As the internal pressure of the HID headlight bulb and halogen bulb is high, dropping, hitting or damaging the bulb may result in it exploding and shattering.
Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
Always replace a bulb with another bulb of the same wattage.
If only replacing the bulbs on one side, differences in brightness and lighting color between the right and left sides may occur.
Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may be filled with water through gaps around the socket if it is not installed securely.
Do not break the HID headlight bulb when disposing of it as shards of glass may fly off and cause injuries.
As the HID headlight bulb cannot be determined to be defective or not by checking it visually, check it by replacing the bulb with a new or known good one.
PRECAUTIONS FOR VEHICLE EQUIPPED WITH AFS
When removing/installing or replacing the height control sensor, performing work that changes the vehicle height such as replacement of the suspension, or replacing the AFS ECU, initialization must be performed (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>INITIALIZATION).
When disconnecting the cable of the negative (-) battery terminal, it is necessary to store the steering angle sensor neutral point after the cable is reconnected (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>INITIALIZATION).