The AFS ECU receives the steering angle signal from the steering angle sensor via the CAN communication line.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2414 | AFS ECU cannot receive signal from steering angle sensor normally | ·
AFS ECU ·
Steering angle sensor ·
CAN communication system |
Replace the steering angle sensor.
NEXT
Check for DTCs again.
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
NEXT
Perform initialization (see page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>INITIALIZATION).
NEXT
Adjust the steering angle sensor (see page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>INITIALIZATION).
NEXT