VISUAL CHECK
Perform a visual check for burned-out bulbs, blown-out fuses, wire harness disconnection, short circuits and loose connection of connectors.
ILLUMINATED ENTRY FUNCTION OPERATION CHECK
Illuminated entry function controls the following lights:
Engine switch light
Inside handle illumination light
Map light
Room light
Check that the lights come on when unlocking any of the doors that are closed and locked with the engine switch off. Then check that the lights fade out under the following conditions:
Leave the doors unlocked for 15 seconds.
Turn the engine switch on (ACC or IG).
Lock all the doors.
Check that the lights stay on for at least 15 seconds after opening any of the doors before fading out. Then check that the lights fade out 15 seconds after closing all the doors.
Check that the lights stay lit after turning the engine switch off with all the doors closed and the engine switch in the on (ACC or IG). Then check that the lights fade out under the following conditions:
Leave the doors unlocked for 15 seconds.
Turn the engine switch on (ACC or IG).
Lock all the doors.
Check that the lights stay on for at least 15 seconds after opening any of the doors. Then check that the lights fade out 15 seconds after closing all the doors.
Check that the lights come on when opening any of the doors and fade out when closing and locking all the doors or turning the engine switch on (ACC or IG).
INSIDE HANDLE ILLUMINATION LIGHT OPERATION CHECK
Check that the lights come on when unlocking any of the doors that are closed and locked with the engine switch off. Then check that the lights fade out under the following conditions:
Leave the doors unlocked for 15 seconds.
Lock all the closed doors and turn the engine switch off.
Check that the lights stay on for at least 15 seconds under the following conditions before going off.
Turn the engine switch on (IG), and shift the shift lever to the P position.
Open any of the doors.
Check that the lights dim before going off under the following conditions.
Turn the engine switch on (IG) and shift the shift lever into any position other than P.
Check the conditions below before the lights go off.
The lights dim when shifting into a position other than P and closing all the doors with the engine switch on (IG).
The lights come on for 15 seconds and fade out when shifting into the P position and closing all the doors with the engine switch off.
Check that the lights come on after opening any of the doors.
Check that the lights fade out 15 seconds after closing all the doors, or locking all the doors.
Check that the lights come on gradually with the engine switch on (IG) and the shift lever in the P position.
Check that the lights dim when shifting from P into another position with all the doors closed.
Check that the lights stay dimmed with the engine switch on (IG) and the shift lever in a position other than P.
BATTERY SAVER OPERATION CHECK
Turn the engine switch off and close all the doors.
Open any door to turn the map (room) light on, and leave it open. Check that the light goes off after about 20 minutes.
After the map (room) light goes off, close the driver's door.
Open any door to turn the map (room) light on, and then open another door. Check that the map (room) light goes off within 20 minutes after opening the doors.
Close all the doors. Open any door to turn the map (room) light on. Check that the map (room) light goes off within 20 minutes.
LIGHT AUTO TURN OFF OPERATION CHECK
Turn the engine switch on (IG), and turn the headlight dimmer switch (light control switch) to the TAIL or HEAD position.
Turn the engine switch off and any door (except the luggage compartment door) opens, and check that the headlights, tail lights, front fog lights and rear fog light go off immediately.
Turn the engine switch on (IG), and turn the headlight dimmer switch (light control switch) to the AUTO position.
Check that the headlights, taillights, front fog lights, and rear fog lights go off when turning the engine switch off and opening any door (except the luggage compartment door) while the automatic light control function is working with the light on.
AUTOMATIC LIGHT CONTROL OPERATION CHECK
Turn the engine switch on (IG).
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor and check that the taillights and headlights come on in order.
Uncover the automatic light control sensor and check that the headlights and taillights go off in order.
AFS OPERATION CHECK
When the engine is started, check that the headlight leveling motor and headlight swivel motor operate.
Check that the AFS operation starts / stops according to the vehicle conditions (see page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>SYSTEM DESCRIPTION).