The AFS ECU operates the headlight leveling motor in accordance with the vehicle height (depending on the number of occupants).
The AFS ECU also receives information from the headlight leveling motor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2424 | AFS ECU cannot communicate with headlight leveling motor LH normally for 1 second or more | ·
Headlight leveling motor LH ·
AFS ECU ·
Wire harness |
| B2425 | AFS ECU cannot communicate with headlight leveling motor RH normally for 1 second or more | ·
Headlight leveling motor RH ·
AFS ECU ·
Wire harness |
Remove the GAUGE NO. 1 fuse from the main body ECU.
Measure the resistance of the fuse.
Below 1 Ω
OK
NG
Disconnect the A28 ECU connector.
Measure the voltage and resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A28-15 (IG) - Body ground | Ignition switch on (IG) | 10 to 14 V |
| Tester Connection | Specified Condition |
|---|---|
| A28-22 (E1) - Body ground | Below 1 Ω |
OK
NG
Disconnect the A28 ECU connector.
Disconnect the B3 (for LH) and B18 (for RH) leveling motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| A28-3 (LL1+) - B3-1 (LHIG) | Below 1 Ω |
| A28-27 (LL1-) - B3-3 (LH E) | Below 1 Ω |
| A28-30 (LHT) - B3-2 (LH T) | Below 1 Ω |
| A28-3 (LL1+) or B3-1 (LHIG) - Body ground | 10 kΩ or higher |
| A28-27 (LL1-) or B3-3 (LH E) - Body ground | 10 kΩ or higher |
| A28-30 (LHT) or B3-2 (LH T) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
|---|---|
| A28-4 (LR1+) - B18-1 (RHIG) | Below 1 Ω |
| A28-28 (LR1-) - B18-3 (RH E) | Below 1 Ω |
| A28-11 (RHT) - B18-2 (RH T) | Below 1 Ω |
| A28-4 (LR1+) or B18-1 (RHIG) - Body ground | 10 kΩ or higher |
| A28-28 (LR1-) or B18-3 (RH E) - Body ground | 10 kΩ or higher |
| A28-11 (RHT) or B18-2 (RH T) - Body ground | 10 kΩ or higher |
OK
NG
Reconnect the A28 ECU connector.
Measure the voltage and resistance of the connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (LL1+) - Body ground | Ignition switch on (IG) | 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (LR1+) - Body ground | Ignition switch on (IG) | 10 to 14 V |
| Tester Connection | Specified Condition |
|---|---|
| 27 (LL1-) - Body ground | Below 1 Ω |
| Tester Connection | Specified Condition |
|---|---|
| 28 (LR1-) - Body ground | Below 1 Ω |
OK
NG
Replace the headlight leveling motor LH or RH with a new one.
Check for DTCs again.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
NEXT
Perform initialization (see page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>INITIALIZATION).
NEXT