Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81740
1.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
Install the side turn signal light with the 2 screws.
87945B
2.INSTALL OUTER MIRROR COVER LH
Attach the 8 claws to install the cover.
87940
3.INSTALL OUTER REAR VIEW MIRROR
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.