Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81340B
1.INSTALL VANITY LIGHT BULB
Install the light bulb to the vanity light.
81340
2.INSTALL VANITY LIGHT ASSEMBLY
Attach the 2 claws to install the vanity light lens.
Install the vanity light.
74320
3.INSTALL VISOR ASSEMBLY LH
Attach the 2 claws to install the visor.
Install portion A of the visor to the visor holder.
Attach the 4 claws to install the visor bracket cover.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.