Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81210C
1.INSTALL REAR FOG LIGHT BULB
Install the bulb to the socket.
81210R
2.INSTALL REAR FOG LIGHT ASSEMBLY
Connect the connector.
Install the rear fog light with the 2 screws.
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.