Home › Vehicle Interior › LIGHTING › HIGH INTENSITY DISCHARGE HEADLIGHT BULB
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291959 HIGH INTENSITY DISCHARGE HEADLIGHT BULB A

LIGHTING  HIGH INTENSITY DISCHARGE HEADLIGHT BULB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81110L 1.INSTALL DISCHARGE HEADLIGHT BULB

a.
E183210E02
1.042,2.188 1.24,2.354 0.198,0.167 10 true (1) 1.344,1.344 1.542,1.51 0.198,0.167 10 true (2) 1.969,1.323 2.167,1.49 0.198,0.167 10 true (2)

Lock the set spring to install the discharge headlight bulb in the direction indicated by the arrow shown in the illustration.

NOTICE:

Do not touch the bulb glass.



b.
E183212

Turn the light control ECU socket in the direction indicated by the arrow shown in the illustration to connect it.


Hide 81139 2.INSTALL HEADLIGHT SOCKET COVER

a.
E183214

Install the headlight socket cover and turn it clockwise to complete the installation.


Hide 3.INSTALL FRONT FENDER LOWER LINER

E130678

a.

Install the front fender lower liner with the 2 screws and 2 clips.


b.

Turn the steering wheel to the left and straighten the front tires.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.