Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL REAR LIGHT ASSEMBLY
Engage the pin to temporarily install the rear light assembly.
Install the rear light assembly with the 3 nuts.
Connect the connector.
84280D
2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
67750
3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
62581H
4.INSTALL REAR WINDOW SIDE GARNISH RH
62582H
5.INSTALL REAR WINDOW SIDE GARNISH LH
67848
6.INSTALL BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)
67939D
7.INSTALL BACK DOOR CENTER GARNISH
8.INSTALL REAR COMBINATION LIGHT ASSEMBLY
Connect the connector.
Engage the rear combination light guide to temporarily install the rear combination light assembly as shown in the illustration.
| *1 | Rear Combination Light Guide |
Install the rear combination light assembly with the 2 screws.