Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) J

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  Headlight Leveling ECU Power Source Circuit  


DESCRIPTION

This circuit detects the state of the engine switch, and sends it to the headlight leveling ECU assembly.

WIRING DIAGRAM

E223770E33
4.844,2.76 7.021,2.948 2.177,0.188 10 false Headlight Leveling ECU Assembly 4.844,2.583 5.125,2.771 0.281,0.188 10 false A39 0.781,1.104 2.146,1.292 1.365,0.188 10 false from LH-IG Relay 5.479,1.083 5.677,1.281 0.198,0.198 10 false IG 5.479,2.167 5.677,2.365 0.198,0.198 10 false E1 5.281,2.063 5.385,2.208 0.104,0.146 10 false 9 5.271,0.969 5.396,1.146 0.125,0.177 10 false 1 3.344,1.292 4.375,1.51 1.031,0.219 10 false GAUGE NO. 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Data List.


e.

Read the Data List according to the display on the GTS.

HL AutoLeveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
+B IG power supply voltage value / 0.00 to 19.75 V 11.00 to 14.00 V -

OK:

Normal condition listed above is displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A39 headlight leveling ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A39-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V
A39-1 (IG) - Body ground Engine switch off Below 1 V




OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A39-9 (E1) - Body ground Always Below 1 Ω




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR