Home › Vehicle Interior › LIGHTING › HEADLIGHT LEVELING ECU › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291966 HEADLIGHT LEVELING ECU A

LIGHTING  HEADLIGHT LEVELING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 4.REMOVE COWL SIDE TRIM BOARD LH

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55550 6.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 88650E 7.REMOVE NO. 1 AIR CONDITIONING AMPLIFIER ASSEMBLY

a.
E275819

Disengage the 2 clamps.


b.
E216411

Disconnect each connector.


c.
E168939

Remove the bolt and nut, and disconnect the passenger side junction block assembly as shown in the illustration.


d.

Disconnect each connector.


e.
E131539

Remove the 2 screws and No. 1 air conditioning amplifier assembly.


Hide 89960 8.REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

a.
E130674

Remove the 2 nuts.


b.

Disconnect the connector to remove the headlight leveling ECU assembly.