Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) J

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  Parking Brake Switch Circuit  


DESCRIPTION

The main body ECU detects the condition of the parking brake switch assembly.

WIRING DIAGRAM

E349358E03
1.594,1.427 2.052,1.625 0.458,0.198 10 false A36 1.583,1.573 3.563,2.042 1.979,0.469 10 false Parking Brake Switch Assembly 2.698,0.958 3.156,1.156 0.458,0.198 10 false 1 4.042,0.938 4.5,1.135 0.458,0.198 10 false 13 4.354,2.01 4.813,2.208 0.458,0.198 10 false 4D 5.979,1.073 6.438,1.271 0.458,0.198 10 false PKB 4.333,2.167 6.875,2.583 2.542,0.417 10 false Main Body ECU

PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Parking Brake SW Parking brake switch signal/ON or OFF ON: Parking brake switch on
OFF: Parking brake switch off
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.
C211519E12
0.188,0.188 0.521,0.469 0.333,0.281 10 false *a

Remove the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE PEDAL>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Shaft pushed in (OFF) 10 kΩ or higher
1 - Switch body Shaft not pushed in (ON) Below 1 Ω


Text in Illustration
*a Component without harness connected
(Parking Brake Switch Assembly)



OK

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - MAIN BODY ECU)

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - MAIN BODY ECU)
a.

Disconnect the 4D main body ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A36-1 - 4D-13 Always Below 1 Ω
A36-1 or 4D-13 - Body ground Always 10 kΩ or higher




OK

REPLACE MAIN BODY ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR