1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
55302A
2.REMOVE UPPER INSTRUMENT PANEL
Remove the upper instrument panel (see page Vehicle Interior>INTERIOR PANEL>UPPER INSTRUMENT PANEL>REMOVAL ).
55312
3.REMOVE LOWER INSTRUMENT PANEL
Remove the lower instrument panel (see page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL).
4.REMOVE FRONT SEAT ASSEMBLY LH (for LHD)
for Manual Seat:
Remove the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
5.REMOVE FRONT SEAT ASSEMBLY RH (for RHD)
for Manual Seat:
Remove the front seat RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
58810J
6.REMOVE CONSOLE BOX ASSEMBLY
Remove the console box (see page Vehicle Interior>INTERIOR>REAR CONSOLE BOX>REMOVAL).
7.DISCONNECT PARKING BRAKE SWITCH CONNECTOR
8.REMOVE LOCK NUT
for Single Nut Type:
Remove the self-lock nut.
for Double Nut Type:
Remove the lock nut and No. 1 wire adjusting nut.
46410
9.DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
for LHD:
Remove the 4 bolts.
for RHD:
Remove the 3 bolts.
Remove the clip.
Disconnect the inner guide of the No. 1 parking brake cable from the crossmember.
Disconnect the No. 1 parking brake cable from the parking brake equalizer.
46200
10.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 4 nuts and parking brake control pedal (with the No. 1 parking brake cable).