Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059566 AUDIO / VIDEO _0291977 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  01-D5  Absence of Registration Unit  01-D8  No Response for Connection Check  01-D9  Last Mode Error  01-DA  No Response Against ON / OFF Command  01-DB  Mode Status Error  01-DE  Slave Reset  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
01-D5*1,*4 When either condition below is met:
·

Device that sub-code shows is (was) disconnected from system when turning engine switch on (IG or ACC)

·

Communication condition with device that code shows cannot be obtained when engine starts


·

Power source circuit of component shown by sub-code

·

AVC-LAN circuit between radio receiver and component shown by sub-code

·

Component shown by sub-code


01-DB*2,*4 Device indicated by sub-code is (was) disconnected from system after engine starts
01-D9*1,*4 Device that had functioned before engine stopped is (was) disconnected from system when engine switch is (was) on (IG or ACC)
01-DA*4 When either condition below is met:
·

No response is identified when changing mode

·

Detected when sound and image do not change by switch operation


01-DB*1,*4 Dual alarm is detected
01-DE*3,*4 Code is stored when slave device has been disconnected after engine starts

HINT:
·

*1: Even if no failure is detected, a trouble code may be recorded depending on the battery condition or engine start voltage.

·

*2: If the power connector is disconnected after the engine starts, this code is recorded after 180 seconds.

·

*3: This code may be stored if the engine is started.

·

*4: If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the device.



NOTICE:
·

Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.

·

The radio receiver is the master unit.

·

Be sure to clear and recheck for DTCs after the inspection is completed to confirm that no DTCs are output.



CAUTION / NOTICE / HINT

NOTICE:

Be sure to read the DESCRIPTION before performing the following procedures.


PROCEDURE

1.CHECK "RADIO RECEIVER COMMUNICATION ERROR" IN FLOWCHART

NEXT

END