| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-DF* | When either condition below is met:
·
Device with display fails and master is switched to audio device ·
Also when communication error between sub-master (audio) and master occurs, this code is stored |
·
Radio receiver power source circuit ·
AVC-LAN circuit between radio receiver and component which has stored this code ·
Radio receiver ·
Component which has stored this code |
*: When 210 seconds have elapsed after disconnecting the power supply connector of the master component with the engine switch on (IG or ACC) position, this code is stored.
Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
The radio receiver is the master unit.
Be sure to clear and recheck for DTCs after the inspection is completed to confirm that no DTCs are output.
Be sure to read the DESCRIPTION before performing the following procedures.
Refer to the radio receiver power source circuit (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>Radio Receiver Communication Error).
If the power source circuit is operating normally, proceed to the next step.
NEXT
Disconnect the F10 receiver connector.
Measure the resistance of the receiver.
| Tester Connection | Specified Condition |
|---|---|
| F10-9 (TXM+) - F10-10 (TXM-) | 60 to 80 Ω |
OK
NG
Enter the diagnostic mode.
Press the preset switch "2" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical address |
|---|---|
| Television display assembly | 1B0 |
"440 (Stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.
For details of the DTC display, refer to the "DTC CHECK / CLEAR" (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
For details of the connectors, refer to the "Terminals of ECU" (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>TERMINALS OF ECU).
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver and the component which has stored this code.
There is no open or short circuit.
OK
NG
Replace the radio receiver with a normal one and check if the same problem occurs again.
Same problem does not occur.
OK
NG