Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat) › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059567 SEAT _0291998 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the RH side.



PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the seat in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect the connector under the seat.


c.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


d.
B136532E02
1.313,0.385 1.563,0.583 0.25,0.198 10 true 1 2.625,0.094 2.823,0.292 0.198,0.198 10 false 2

Tighten the 2 bolts on the front side of the seat.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



e.
B136531E02
2.583,0.365 3.021,0.615 0.438,0.25 10 false Close 1.51,1.135 1.948,1.385 0.438,0.25 10 true Close

Attach the 4 claws on the front side of the front seat leg cover. Then close the 2 covers.


f.

Lift up the seat track adjusting handle and move the seat to the foremost position.


g.
B141472E01
1.895,0.924 2.074,1.080 0.179,0.156 10 1 0.366,0.208 0.517,0.359 0.151,0.151 10 2

Tighten the 2 bolts on the rear side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



h.
B136534E01
0.098,0.25 0.750,0.493 0.652,0.242 10 Close 1.602,1.139 2.254,1.382 0.652,0.242 10 Close

Attach the 4 claws on the rear side of the front seat leg cover. Then close the 2 covers.


Hide 2.INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS

a.

During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.

If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.


Hide 71910A 3.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 28800 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 6.CHECK SRS WARNING LIGHT

Hide 7.INSPECT FRONT SEAT ASSEMBLY

a.

w/ Seat Heater System:

Check the seat heater operation.

i.

Turn the ignition switch on (IG).


ii.

Push the seat heater switch ON.


iii.

Wait 5 minutes or more and confirm that the seat surface becomes warm.