Wear protective gloves. Sharp areas on the front seat frame with adjuster may injure your hands.
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
71140
1.REMOVE FRONT SEAT LEG ASSEMBLY LH
Remove the 2 nuts and seat leg.
72143A
2.REMOVE FRONT SEAT TRACK BRACKET
Remove the 4 nuts and 2 brackets.
71139L
3.REMOVE FRONT SEAT LEG COVER
Remove the 2 leg covers.
72459A
4.REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Driver Side)
Using a screwdriver, detach the 3 claws and remove the cap.
Tape the screwdriver tip before use.
72493
5.REMOVE NO. 2 VERTICAL ADJUSTING HANDLE (for Driver Side)
Remove the 2 screws and handle.
72457D
6.REMOVE VERTICAL SEAT ADJUSTER KNOB LH (for Driver Side)
Using a screwdriver, remove the snap ring as shown in the illustration. Then remove the knob.
Tape the screwdriver tip before use.
72526A
7.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Driver Side)
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.
Tape the screwdriver tip before use.
72525A
8.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Front Passenger Side)
Use the same procedures described for the driver side.
71812D
9.REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)
Disconnect the 2 rubber bands of the front seatback cover from the front seat frame with adjuster.
Remove the screw.
Using a screwdriver, detach the 2 claws and clip, and remove the cushion shield.
Tape the screwdriver tip before use.
71811D
10.REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
Disconnect the 2 rubber bands of the front seatback cover from the front seat frame with adjuster.
Remove the screw.
Using a screwdriver, detach the 2 claws and clip, and remove the cushion shield.
Tape the screwdriver tip before use.
71862
11.REMOVE FRONT SEAT CUSHION INNER SHIELD LH
Remove the screw.
Using a screwdriver, detach the 2 claws and clip, and remove the inner shield.
Tape the screwdriver tip before use.
73240
12.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
72878
13.REMOVE SEAT ARMREST COVER LH
Using a screwdriver, detach the 3 claws and remove the armrest cover.
Tape the screwdriver tip before use.
72880A
14.REMOVE FRONT SEAT INNER ARMREST ASSEMBLY LH
Remove the bolt and front seat inner armrest assembly LH.
71072S
15.REMOVE FRONT SEAT CUSHION COVER
w/ Seat Heater System:
Disconnect the connector.
Using a clip remover, remove the 2 clips and hooks.
If clips are damaged during removal, replace them.
Detach the 2 hooks on the seat cushion front side. Then remove the seat cushion cover (with pad) from the front seat frame with adjuster.
for Type A:
Remove the 14 hog rings and front seat cushion cover from the front seat cushion pad.
for Type B:
Remove the 16 hog rings and front seat cushion cover from the front seat cushion pad.
71073S
16.REMOVE FRONT SEATBACK COVER
Remove the 2 front seatback pocket clips.
Open the lower part of the front seatback cover and remove the 5 hog rings.
Remove the 3 hog rings and disengage the fastening rubber.
w/ Front Seat Side Airbag:
Remove the nut and move the 2 seatback cover brackets.
Pull back the front seatback cover and remove the 3 hog rings.
Detach the 4 claws and remove the 2 headrest supports.
Remove the seatback cover (with pad) from the front seat frame with adjuster.
for Type A:
Remove the 4 hog rings and front seatback cover from the front seatback pad.
for Type B:
w/o Seat Heater System:
Remove the 2 hog rings.
Disengage the fastening tape and remove the front seatback cover from the front seatback pad.
w/ Seat Heater System:
Remove the 4 hog rings.
Disengage the fastening tape and remove the front seatback cover from the front seatback pad.
71876A
17.REMOVE RECLINING ADJUSTER LOWER INSIDE COVER LH
Remove the screw.
Detach the claw and remove the inside cover.
w/ Front Seat Side Airbag:
Detach the clamp of the side airbag and disconnect the wire harness.
71875B
18.REMOVE RECLINING ADJUSTER LOWER INSIDE COVER RH
Remove the screw.
Detach the claw and remove the inside cover.
71876B
19.REMOVE RECLINING ADJUSTER UPPER INSIDE COVER LH
Remove the screw and inside cover.
71875E
20.REMOVE RECLINING ADJUSTER UPPER INSIDE COVER RH
Remove the screw and inside cover.
71874
21.REMOVE FRONT SEAT CUSHION LOWER SHIELD LH
Using a screwdriver, detach the claw and remove the lower shield.
Tape the screwdriver tip before use.
71873
22.REMOVE FRONT SEAT CUSHION LOWER SHIELD RH
Use the same procedures described for the LH side.
72477
23.REMOVE VERTICAL ADJUSTER SPACER
Using a screwdriver, detach the claw and remove the spacer.
Tape the screwdriver tip before use.
71643A
24.REMOVE ACTIVE HEADREST UPPER UNIT
Remove the nut and disconnect the cable from the active headrest upper unit as shown in the illustration.
Remove the 4 nuts and active headrest upper unit.
71644
25.REMOVE ACTIVE HEADREST LOWER UNIT
Remove the clamp.
Remove the 2 nuts and active headrest lower unit.
71499B
26.REMOVE SEAT CUSHION SPRING DAMPER
Remove the 2 nuts and seat cushion spring damper.
82192
27.REMOVE FRONT SEAT WIRE LH
Disengage each clamp and remove the front seat wire LH.
71537D
28.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH
Remove the 2 protectors.
29.REMOVE SEAT TRACK ADJUSTING HANDLE