Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059567 SEAT _0291999 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Use the same procedures for the LH and RH side.


PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the seat in the cabin.


b.

Connect the connectors under the seat.


c.

Connect the cable to the negative (-) battery terminal.


d.
B146170

Operate the power seat switch knob and move the seat to the rearmost position.


e.

Tighten the 2 bolts on the front side of the seat.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)

HINT:

Tighten the 2 bolts in the order indicated in the illustration.



f.
B146176

Attach the 4 claws on the front side of the front seat leg cover. Then close the 2 covers.


g.
B141472E01
1.895,0.924 2.074,1.080 0.179,0.156 10 1 0.366,0.208 0.517,0.359 0.151,0.151 10 2

Operate the power seat switch knob and move the seat to the foremost position.


h.

Tighten the 2 bolts on the rear side of the seat.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)

HINT:

Tighten the 2 bolts in the order indicated in the illustration.



i.
B136534E01
0.098,0.25 0.750,0.493 0.652,0.242 10 Close 1.602,1.139 2.254,1.382 0.652,0.242 10 Close

Attach the 4 claws on the rear side of the front seat leg cover. Then close the 2 covers.


Hide 71910A 2.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 3.CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)

Hide 4.INSPECT FRONT SEAT ASSEMBLY

a.

Check the power seat operation.


b.

w/ Seat Heater System:

Check the seat heater operation.

i.

Turn the ignition switch on (IG).


ii.

Push the seat heater switch ON.


iii.

Wait 5 minutes or more and confirm that the seat surface becomes warm.



Hide 5. PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.