Home › Vehicle Interior › DOOR LOCK › SMART ENTRY AND START SYSTEM › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059568 DOOR LOCK _0292017 SMART ENTRY AND START SYSTEM J

DOOR LOCK  SMART ENTRY AND START SYSTEM  All Door Entry Lock and Unlock Functions do not Operate  


DESCRIPTION

When the key cancel function is ON, all entry functions stop operating. If the key cancel function is operated but all entry functions stop operating, one of the following is malfunctioning: 1) key cancel function, 2) certification ECU or 3) wire harness.

PROCEDURE

1.CHECK FOR DTC
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the tester ON.


c.

By following the tester screen display, check whether any DTCs are output.

Result:
Result Proceed to
DTC output (for 2AZ-FE) A
DTC output (for 2GR-FE) B
No DTC output C




C

2.CHECK KEY CANCEL FUNCTION

A

B

2.CHECK KEY CANCEL FUNCTION
a.

Check that the key cancel function has been set (see page Vehicle Interior>DOOR LOCK>SMART ENTRY AND START SYSTEM>CUSTOMIZE PARAMETERS).

OK:

Key cancel function is set.




NG

3.CHECK MANUAL DOOR LOCK AND UNLOCK OPERATION

OK

END (UNSET KEY CANCEL FUNCTION)

3.CHECK MANUAL DOOR LOCK AND UNLOCK OPERATION
a.

Check that all the doors lock when the door control switch (for manual operation) is turned to LOCK and all doors unlock when turned to UNLOCK.

OK:

All doors can be locked and unlocked with door control switch.




OK

4.CHECK WIRELESS DOOR LOCK CONTROL OPERATION

NG

4.CHECK WIRELESS DOOR LOCK CONTROL OPERATION
a.

Check that the wireless door lock and unlock functions operate normally.

OK:

Wireless door lock and unlock functions operate normally.




OK

5.CHECK DOOR CONTROL TRANSMITTER (OPERATION)

NG

GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (w/ SMART ENTRY AND START SYSTEM)

5.CHECK DOOR CONTROL TRANSMITTER (OPERATION)
a.

Temporarily replace the door control transmitter with a new or normally functioning one.


b.

Check that the entry lock and unlock functions operate normally (see page Vehicle Interior>DOOR LOCK>SMART ENTRY AND START SYSTEM>OPERATION CHECK).

OK:

Entry lock and unlock functions operate normally.




NG

6.READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY LIGHT SWITCH)

OK

END (DOOR CONTROL TRANSMITTER IS DEFECTIVE)

6.READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY LIGHT SWITCH)
a.

Check the Data List to confirm the operations of each door courtesy light switch.

Main body ECU:
Item Measurement Item / Range (Display) Normal Condition Diagnostic Note
D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON: Driver side door is open
OFF: Driver side door is closed
-
P Door Courtesy SW Front passenger side door courtesy light switch signal / ON or OFF ON: Front passenger side door is open
OFF: Front passenger side door is closed
-
RL Door Courtesy SW Rear door LH courtesy light switch signal / ON or OFF ON: Rear door LH is open
OFF: Rear door LH is closed
-
RR Door Courtesy SW Rear door RH courtesy light switch signal / ON or OFF ON: Rear door RH is open
OFF: Rear door RH is closed
-

OK:

On tester screen, items change between ON and OFF according to above chart.




OK

REPLACE CERTIFICATION ECU

NG