53630
1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
Install the cable to the clamps, wire harness protector and wire harness grommet as shown in the illustration.
53601
2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the cable to the lever.
Attach the 3 claws to install the lever.
53510
3.INSTALL HOOD LOCK ASSEMBLY
Connect the cable to the lock.
Install the lock with the 3 bolts.
Adjust the lock.
w/ Hood Courtesy Switch:
Connect the connector.
53289A
4.INSTALL RADIATOR SUPPORT OPENING COVER
28800
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6.PERFORM INITIALIZATION
Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
7.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).