Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059570 CRUISE CONTROL _0292039 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Malfunction  P0503  Vehicle Speed Sensor "A" Intermittent / Erratic / High  


DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>P0500 for 2AZ-FE, Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>P0500 for 2GR-FE). The speed signal is converted for use by the cruise control inside the ECM. Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.

DTC No. DTC Detection Condition Trouble Area
P0500 The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while cruise control is in operation.
·

Open or short in speed signal circuit

·

Combination meter

·

Skid control ECU

·

Vehicle speed sensor

·

Headlight beam level control ECU

·

Main body ECU

·

Radio receiver assembly

·

Navigation receiver assembly

·

Windshield wiper relay

·

Clearance warning ECU

·

ECM


P0503 Momentary interruption and noise are detected when a rapid change of vehicle speed occurs while cruise control is in operation.
·

Open or short in speed signal circuit

·

Combination meter

·

Skid control ECU

·

Vehicle speed sensor

·

Headlight beam level control ECU

·

Main body ECU

·

Radio receiver assembly

·

Navigation receiver assembly

·

Windshield wiper relay

·

Clearance warning ECU

·

ECM



WIRING DIAGRAM

Refer to SFI system for 2AZ-FE (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>P0500).

Refer to SFI system for 2GR-FE (See page Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>P0500)

PROCEDURE