Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

DTCs which are stored in the ECM can be output to the intelligent tester.

The tester can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / DTC.


v.

Confirm the DTCs and freeze frame data, and then write them down.


vi.

Confirm the details of the DTCs (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).

NOTICE:

When simulating a symptom with the scan tool to check for DTCs, use normal mode. For codes on the Diagnostic Trouble Code Chart subject to "2 trip detection logic", perform the following actions:

Turn the engine switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL illuminates and the DTCs are stored in the ECM.





CLEAR DTC (using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.



CLEAR DTC (without using intelligent tester)


a.

Perform either of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI and ETC-S fuses from the engine room relay block located inside the engine compartment for more than 1 minute (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PARTS LOCATION).