K112 (CVT)
CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
- PRECAUTION2013.04–2014.09from 2014.09
- DEFINITION OF TERMS
- PARTS LOCATION2013.04–2014.092014.09–2016.05from 2016.05
- SYSTEM DIAGRAM2013.04–2014.092014.09–2016.05from 2016.05
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING2013.04–2014.092014.09–2016.05from 2016.05
- ROAD TEST
- MECHANICAL SYSTEM TESTS
- HYDRAULIC TEST
- INITIALIZATION2013.04–2014.09from 2014.09
- PROBLEM SYMPTOMS TABLE2013.04–2014.092014.09–2016.05from 2016.05
- TERMINALS OF ECM2013.04–2016.05from 2016.05
- DIAGNOSIS SYSTEM2013.04–2016.05from 2016.05
- DTC CHECK / CLEAR2013.04–2014.092014.09–2016.05from 2016.05
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST2013.04–2014.092014.09–2016.05from 2016.05
- DIAGNOSTIC TROUBLE CODE CHART2013.04–2014.092014.09–2016.05from 2016.05
- P0705 1. Engine switch on (IG) and battery voltage is 10.5 V or more 2. Any 2 or more of the following signals are...2013.04–2014.092014.09–2016.05from 2016.05
- P0711 1. The intake air and engine coolant temperatures are more than -10°C (14°F) at engine start, and the vehicle...2013.04–2014.092014.09–2016.05from 2016.05
- P0712, P07132013.04–2014.092014.09–2016.05from 2016.05
- P0715, P0717 from 2016.05
- P0717 1. The vehicle is driven with the shift lever in D, the output shaft speed is 300 rpm or more, and no error...2013.04–2014.092014.09–2016.05
- P0720, P0722 from 2016.05
- P0722 1. The vehicle is driven with the shift lever in D, the output shaft speed is 300 rpm or more, and no error...2013.04–2014.092014.09–2016.05
- P0741, P27572013.04–2014.092014.09–2016.05from 2016.05
- P0746, P07762013.04–2014.092014.09–2016.05from 2016.05
- P0840, P0842, P08432013.04–2014.09from 2014.09
- P0841, P28292013.04–2014.092014.09–2016.05from 2016.05
- P0962, P0963, P0966, P09672013.04–2014.09from 2014.09
- P1585 1. The engine switch is on (IG). 2. The output value of the yaw rate sensor remains at -1.5 G or less, or 1.5...2013.04–2014.092014.09–2016.05from 2016.05
- P1586 1. The engine switch is on (IG). 2. With a vehicle speed of 30 km/h (18 mph) or more, the difference between...2013.04–2014.092014.09–2016.05from 2016.05
- P1589 1. The vehicle speed is 2 km/h (1.2 mph) or more. 2. Deceleration sensor 0 point calibration has not been...2013.04–2014.092014.09–2016.05from 2016.05
- P1750 1. - 2. The ECM receives an error signal from the brake actuator assembly (skid control ECU). 3. 3 seconds 4....2013.04–2014.092014.09–2016.05from 2016.05
- P2763, P27642013.04–2014.09from 2014.09
- P2767 1. The vehicle is driven with the shift lever in D, the output shaft speed is 300 rpm or more and the vehicle...2013.04–2014.09from 2014.09
- P2769, P27702013.04–2014.09from 2014.09
- P282B 1. The vehicle is being driven. 2. There is an open or short circuit in the shift solenoid valve SLS circuit....2013.04–2014.09from 2014.09
- U0129 1. The engine switch is on (IG). 2. There is no communication between the ECM and skid control ECU. 3. 2.4...2013.04–2014.092014.09–2016.05from 2016.05
- Transmission Control Switch Circuit2013.04–2014.092014.09–2016.05from 2016.05
CONTINUOUSLY VARIABLE TRANSAXLE FLUID
CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
TORQUE CONVERTER AND DRIVE PLATE
OIL PAN
OIL COOLER
OIL PRESSURE SENSOR
PARK / NEUTRAL POSITION SWITCH
TRANSMISSION CONTROL CABLE
TRANSMISSION CONTROL CABLE(for LHD)
TRANSMISSION CONTROL CABLE(for RHD)
SHIFT LEVER
SHIFT LEVER(for LHD)
SHIFT LEVER(for RHD)
SPEED SENSOR
DIFFERENTIAL OIL SEAL