Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


HINT:

Intelligent tester only:


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are stored with 1 trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the following conditions are met:

i.

Battery voltage 11 V or higher


ii.

Throttle valve fully closed


iii.

Shift lever in P or N


iv.

A/C turned off



b.

Connect the intelligent tester to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.


f.
C140840E47
0.333,0.719 0.604,0.917 0.271,0.198 10 false ON 0.323,1.51 0.677,1.708 0.354,0.198 10 false OFF 2,0.448 3.01,0.646 1.01,0.198 10 false 0.13 sec. 1.906,1.771 2.802,1.969 0.896,0.198 10 false 0.13 sec.

Check that the MIL flashes as shown in the illustration.

NOTICE:
·

All DTCs and freeze frame data will be cleared if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the engine switch is turned from on (IG) to on (ACC) or off.

·

Before changing to check mode, make notes of the DTCs and freeze frame data.




g.

Start the engine. The MIL should turn off after the engine starts.


h.

Simulate the conditions of the malfunction described by the customer.


i.

After simulating the malfunction conditions, use the intelligent tester to check the DTCs and freeze frame data.