The ECM uses shift solenoid valves DS1 and DS2 to control the in/out CVT fluid flow volumes at the primary pulley to perform gear ratio control.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P0746 | 1.
The engine is warmed up, and with the shift lever in D, the vehicle is accelerating. 2.
The actual gear ratio is higher than the target. 3.
2 seconds 4.
2 trip detection logic |
Continuously variable transaxle assembly |
1.
The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped. 2.
The actual gear ratio is lower than the target. 3.
1 second 4.
2 trip detection logic |
||
| P0776 | 1.
The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped. 2.
The actual gear ratio is lower than the target. 3.
1 second 4.
2 trip detection logic |
|
1.
The engine is warmed up, and with the shift lever in D, the vehicle is accelerating. 2.
The actual gear ratio is higher than the target. 3.
2 seconds 4.
2 trip detection logic |
The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the problem, illuminates the MIL and stores the DTC.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
|---|---|
| Only P0746 and P0776 are output | A |
| P0746 or P0776 and other DTCs are output | B |
If any other DTCs besides P0746 and P0776 are output, perform troubleshooting for those DTCs first.
A
B
(See pageDrivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
NEXT
NEXT