84540
1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Lever Position | Specified Condition |
|---|---|---|
·
1 (RB) - 3 (PL) ·
4 (B) - 9 (L) |
Shift lever in P | Below 1 Ω |
| 1 (RB) - 2 (RL) | Shift lever in R | Below 1 Ω |
·
1 (RB) - 8 (NL) ·
4 (B) - 9 (L) |
Shift lever in N | Below 1 Ω |
| 1 (RB) - 7 (DL) | ·
Shift lever in D ·
Shift lever in M, "+" or "-" |
Below 1 Ω |
·
1 (RB) - 3 (PL) ·
4 (B) - 9 (L) |
Shift lever not in P | 10 kΩ or higher |
| 1 (RB) - 2 (RL) | Shift lever not in R | 10 kΩ or higher |
·
1 (RB) - 8 (NL) ·
4 (B) - 9 (L) |
Shift lever not in N | 10 kΩ or higher |
| 1 (RB) - 7 (DL) | ·
Shift lever not in D ·
Shift lever not in M, "+" and "-" |
10 kΩ or higher |
| *a | Component without harness connected
(Park/Neutral Position Switch) |
If the result is not as specified, replace the park/neutral position switch.