85903
1.INSPECT SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 12 (IG) - 3 (E) | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V | |
| 6 (STP) - 3 (E) | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V | |
| 3 (E) - Body ground | Always | Below 1 Ω |
| *a | Component with harness connected
(Shift Lock Control ECU) |
Do not disconnect the shift lock control unit assembly connector.
If the result is not as specified, replace the shift lock control unit assembly.
2.INSPECT TRANSMISSION CONTROL SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Position | Specified Condition |
|---|---|---|
| 6 (IG) - 13 (S) | M, "+" or "-" | Below 1 Ω |
| Other than M, "+" or "-" | 10 kΩ or higher | |
| 5 (SFTU) - 11 (E) | "+"
Pressed continuously (Up shift) |
Below 1 Ω |
| M | 10 kΩ or higher | |
| 4 (SFTD) - 11 (E) | "-"
Pressed continuously (Down shift) |
Below 1 Ω |
| M | 10 kΩ or higher |
| *a | Component without harness connected
(Transmission Control Switch) |
If the result is not as specified, replace the shift lock control unit.
3.INSPECT SHIFT LOCK SOLENOID
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (P) - 3 (E2) | Shift lever in P | 10 kΩ or higher |
| 4 (P) - 3 (E2) | Shift lever not in P | Below 1 Ω |
| 2 (SLS-) - 1 (SLS+) | Always | 112 Ω |
| *a | Component without harness connected
(Shift Lock Solenoid) |
If the result is not as specified, replace the shift lock control unit.