85903
1.REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
Disconnect the shift lock solenoid connector.
Disengage the 3 claws to remove the shift lock control ECU sub-assembly from the shift lock control unit assembly.
35971A
2.REMOVE UPPER POSITION INDICATOR HOUSING
Cut the cable tie.
Disengage the 4 claws and remove the upper position indicator housing from the shift lock control unit assembly.
| *a | Left Side |
| *b | Right Side |
35975
3.REMOVE POSITION INDICATOR SLIDE COVER
Remove the position indicator slide cover from the shift lock control unit assembly.
35976
4.REMOVE NO. 2 POSITION INDICATOR SLIDE COVER
Remove the No. 2 position indicator slide cover from the position indicator slide cover.
35974
5.REMOVE LOWER POSITION INDICATOR HOUSING
Disengage the claw and remove the connector case from the shift lock control unit assembly as shown in the illustration.
Using a screwdriver, disengage the 2 claws.
Pull up the lower position indicator housing as shown in the illustration to disengage the hook. Then remove the lower position indicator housing from the shift lock control unit assembly.