Home › Engine / Hybrid System › 2GR-FE STARTING › STARTER
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292068 STARTER A

2GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 74404B 4.REMOVE BATTERY CLAMP

a.
A160229

Remove the bolt and loosen the nut.


b.

Detach the 2 wire harness clamps.


c.

Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.


Hide 28899 5.REMOVE BATTERY INSULATOR

Hide 28800 6.REMOVE BATTERY

Hide 74431 7.REMOVE BATTERY TRAY

Hide 74411 8.REMOVE FRONT BATTERY BRACKET

a.
A160230

Detach the 2 wire harness clamps.


b.

Remove the 5 bolts and front bracket.


Hide 74414D 9.REMOVE BATTERY BRACKET REINFORCEMENT

A160231

a.

Remove the 2 bolts and bracket reinforcement.


Hide 28100 10.REMOVE STARTER ASSEMBLY

a.
A160232

Disconnect the starter connector.


b.

Open the terminal cap, remove the nut and disconnect the starter wire.


c.
A160240

Remove the bolt and wire harness clamp bracket.


d.
A160233

Remove the 2 bolts and starter.