This DTC is output when a malfunction occurs in the ACCD output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the man body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2274 | ACC relay actuation circuit inside main body ECU or other related circuit is malfunctioning | ·
Instrument panel junction block LH (Main body ECU) ·
Instrument panel junction block RH ·
Wire harness or connector |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / ACC Relay Mon.
Read the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ACC Relay Monitor | ACC relay monitor / ON or OFF | ON: Engine switch on (ACC)
OFF: Engine switch off |
- |
When the engine switch is turned on (ACC), ON is displayed on the tester.
OK
NG
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the engine switch is pushed.
off → on (ACC) → on (IG) → off
If power mode does not change to ON (IG and ACC) (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>Power Source Mode does not Change to ON (IG and ACC)).
If power mode does not change to ON (IG) (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>Power Source Mode does not Change to ON (IG)).
If power mode does not change to ON (ACC) (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>Power Source Mode does not Change to ON (ACC)).
OK
NG
Disconnect the G57 main body ECU connector.
Disconnect the 5D instrument panel junction block RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| G57-22 (ACCD) - 5D-3 | Below 1 Ω |
| G57-22 (ACCD) or 5D-3 - Body ground | 10 kΩ or higher |
OK
NG
Disconnect the 5A instrument panel junction block RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| 5A-4 - Body ground | Below 1 Ω |
OK
NG
Reconnect the G57 instrument panel junction block RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5D-3 - Body ground | Engine switch on (ACC) | 0.1 to 0.8 V (*1) → Output voltage at terminal AM1 or AM2 is -2 V or more. |
*1: Voltage is output only when the engine is cranking.
Terminal AM1: G57-6
Terminal AM2: G58-1
OK
NG