The main body ECU will set this DTC if the ACCR signal sent from the ECM is ON for 40 seconds or more.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2276 | ACCR output circuit inside main body ECU or other related circuit is malfunctioning | ·
Instrument panel junction block LH (Main body ECU) ·
ECM ·
Wire harness or connector |
Delete the DTCs (See page Engine / Hybrid System>2GR-FE STARTING>PUSH-BUTTON START>DTC CHECK / CLEAR).
After all DTCs are cleared, check if the trouble occurs again 50 seconds after the engine switch is turned on (IG).
Check for DTCs again.
No DTC B2276 is output.
OK
NG
Disconnect the G58 ECU connector.
Disconnect the A7 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G58-3 (ACCR) - A7-13 (ACCR) | Always | Below 1 Ω |
| G58-3 (ACCR) - Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G58-3 (ACCR) - Body ground | Brake pedal depressed, shift P position, engine switch is pushed once → on (IG) | 0.1 to 0.8 V (*1) → Output voltage at terminal AM1 or AM2 is -2 V or more. |
*1: Voltage is output only when the engine is cranking.
Terminal AM1: G57-6
Terminal AM2: G58-1
OK
NG
After replacing the main body ECU with a normally functioning ECU, check that the engine starts. Make sure the brake pedal is depressed and the shift position is P at this time.
Check that the engine switch mode can be changed by pushing the engine switch.
Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.
Engine starts normally.
If engine does not start (See page Engine / Hybrid System>2GR-FE STARTING>PUSH-BUTTON START>Engine does not Start).
OK
NG