Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ECM
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291780 ECM A

2GR-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 85291A 3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 85291B 4.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 53866J 5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

Hide 53867H 6.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

Hide 55781F 7.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 47202 8.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

Hide 9.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Remove the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 11.REMOVE AIR CLEANER CASE

a.
A132379

Disconnect the harness clamp.


b.

Remove the 3 bolts and air cleaner case.


Hide 28800 12.REMOVE BATTERY

a.
A132382

Disconnect the 2 wire harness clamps.


b.

Remove the bolt, nut, and battery clamp.


c.

Remove the battery and battery tray.


Hide 17752 14.REMOVE NO. 2 AIR CLEANER INLET

a.
A132383

Remove the bolt and No. 2 air cleaner inlet.


Hide 89661 15.REMOVE ECM

a.
A132384

Disconnect the wire harness clamp.


b.

Remove the 3 bolts and disconnect the ECM.


c.
A124571E06
0.542,0.719 1.604,0.208 false 1.667,0.115 2.052,0.292 0.385,0.177 10 false Lock 0.594,0.167 0.979,0.458 0.385,0.292 10 true Push

Disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connector, make sure that dirt, water and other foreign matter do not contact the connecting part of the connector.


i.

Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.



d.

Remove the ECM with brackets.


e.
A132385

Remove the 4 screws and 2 ECM brackets.