This DTC is output when a malfunction occurs in the ACCD output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2274 | ACC relay actuation circuit inside main body ECU or other related circuit is malfunctioning | ·
Main body ECU ·
Instrument panel junction block RH (ACC relay) ·
Wire harness |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / ACC Relay Mon.
Read the display on the tester.
| Item | Measurement Item / Display
(Range) |
Normal Condition | Diagnostic Note |
|---|---|---|---|
| ACC Relay Monitor | ACC relay monitor / ON or OFF | ON: Ignition switch on (ACC)
OFF: Ignition switch off |
- |
When the ignition switch is turned on (ACC), ON is displayed on the tester.
OK
NG
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the ignition switch is pushed.
off → on (ACC) → on (IG) → off
OK
NG
Disconnect the G57 main body ECU connector.
Disconnect the 5D instrument panel junction block RH connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G57-22 (ACCD) - 5D-3 | Below 1 Ω |
| G57-22 (ACCD) or 5D-3 - Body ground | 10 kΩ or higher |
OK
NG
Disconnect the 5D instrument panel junction block RH connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5D-3 - Body ground | Ignition switch on (ACC) | 10 to 14 V |
OK
NG