35301A
1.INSTALL FRONT OIL PUMP OIL SEAL
Using SST, install a new oil seal to the pump.
The seal end should be flush with the outer edge of the oil pump.
Coat the lip of the oil seal with petroleum jelly.
35301B
2.INSTALL FRONT OIL PUMP BODY O-RING
Coat a new O-ring with ATF, and install it to the oil pump body.
35322
3.INSTALL FRONT OIL PUMP DRIVEN GEAR
Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
35321
4.INSTALL FRONT OIL PUMP DRIVE GEAR
Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
35370
5.INSTALL STATOR SHAFT ASSEMBLY
Set the stator shaft by aligning each bolt hole.
Using a T30 ''torx'' socket, install the 11 bolts.
35617
6.INSTALL CLUTCH DRUM OIL SEAL RING
Do not expand the ring ends excessively.
Install the 2 clutch drum oil seal rings.
7.INSPECT OIL PUMP ASSEMBLY