1.INSPECT PACK CLEARANCE OF FORWARD CLUTCH
35633B
2.REMOVE FORWARD MULTIPLE DISC CLUTCH DISC
Using a screwdriver, remove the snap ring.
Remove the flange, 5 discs and 5 plates.
35633B
3.INSPECT FORWARD MULTIPLE DISC CLUTCH DISC
35603A
4.REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY
Place SST on the spring retainer and compress the return spring with a press.
Using a snap ring expander, remove the snap ring.
Remove the piston return spring.
35603A
5.INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY
35602A
6.REMOVE FORWARD CLUTCH PISTON SUB-ASSEMBLY
Place the forward clutch drum onto the oil pump.
Holding the forward clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the oil pump to remove the forward clutch piston.
When the piston is slanted and cannot be removed, remove it by pushing down the protruding side and applying compressed air again, or using need-nose pliers (with its tips wrapped in tape).
35602B
7.REMOVE FORWARD CLUTCH PISTON O-RING
Remove the 2 O-rings.
35602A
8.INSPECT FORWARD CLUTCH PISTON SUB-ASSEMBLY
35712A
9.REMOVE INPUT SHAFT OIL SEAL RING