Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › DIRECT CLUTCH
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292092 DIRECT CLUTCH A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  DIRECT CLUTCH  DISASSEMBLY  


PROCEDURE

Hide 35633C 2.REMOVE DIRECT MULTIPLE DISC CLUTCH DISC

a.
D008099

Using a screwdriver, pry out the snap ring from the direct clutch drum.


b.
C129393

Remove the flange, 3 discs and 3 plates from the direct clutch drum.


Hide 35633C 3.INSPECT DIRECT MULTIPLE DISC CLUTCH DISC

Hide 35604 4.REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
D003677E06
2.135,1.01 2.719,1.01 false 2.76,0.927 3.094,1.094 0.333,0.167 10 false SST

Place SST on the clutch balancer and compress the spring with a press.

SST
09387-00020  


b.

Using a snap ring expander, remove the snap ring from the direct clutch drum.

HINT:
·

Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.

·

This prevents the spring sheet from being deformed.

·

Do not expand the snap ring excessively.




c.
D008101

Remove the clutch balancer from the direct clutch drum.


d.
D008102

Remove the piston return spring from the direct clutch drum.


e.
D008103

Install the direct clutch drum on the transaxle rear cover.


f.

Holding the direct clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch piston.


Hide 35604 5.INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY