Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › UNDERDRIVE CLUTCH
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292094 UNDERDRIVE CLUTCH A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  UNDERDRIVE CLUTCH  DISASSEMBLY  


PROCEDURE

Hide 34261 2.REMOVE NO. 1 UNDERDRIVE CLUTCH DISC

a.
D008125

Using a screwdriver, pry out the snap ring.


b.
C129394

Remove the flange, 3 discs and 3 plates from the underdrive clutch drum.


Hide 34205B 4.REMOVE UNDERDRIVE CLUTCH PISTON SET

a.
D003703E09
2.49,0.5 2.896,0.323 false 2.958,0.188 3.271,0.375 0.313,0.188 10 false SST

Place SST on the clutch balancer and compress the spring with a press.

SST
09350-32014  (09351-32070)


b.

Using a snap ring expander, remove the snap ring.

NOTICE:
·

Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.

·

This prevents the spring sheet from being deformed.

·

Do not expand the snap ring excessively.




c.
D003704

Remove the clutch balancer and piston return spring from the underdrive clutch drum.


d.
D008127

Install the underdrive clutch to the transaxle case.

NOTICE:

Be careful not to damage the oil seal rings.



e.
D008128

Holding the underdrive clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.


Hide 34206 5.INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

Hide 34204A 6.REMOVE UNDERDRIVE CLUTCH DRUM O-RING

D004078