Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292096 AUTOMATIC TRANSAXLE SYSTEM D

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


MANUAL SHIFTING TEST


HINT:
·

Through this test, it can be determined whether the trouble occurs in the electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C138438

Disconnect the connector of the transmission wire.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gear positions can then be changed mechanically with the shift lever.



b.

Drive with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.

Shift Lever Position Gear Position
D 3rd
R R
P P


c.

Connect the connector of the transmission wire.