Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE ASSEMBLY › 2013.04–2014.09
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292105 AUTOMATIC TRANSAXLE ASSEMBLY A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

a.

Remove the engine assembly with transaxle (See page Engine / Hybrid System>2AZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).


Hide 3.DRAIN AUTOMATIC TRANSAXLE FLUID

a.

Remove the drain plug and gasket, and drain ATF.


b.

Install a new gasket and the drain plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A133097

Disconnect the starter connector.


b.

Open the terminal cap, remove the nut, and disconnect the starter wire.


c.
A133101

Remove the 2 bolts and starter.


Hide 5.DISCONNECT WIRE HARNESS

a.
C138672

Disconnect the park/neutral position switch connector.


b.

Disconnect the transaxle wire connector.


c.

Disconnect the speed sensor connectors.


d.

Disconnect the wire harness clamps.


Hide 12321A 7.REMOVE REAR ENGINE MOUNTING BRACKET

a.
C138673

Remove the 3 bolts and mounting bracket.


Hide 12311A 8.REMOVE FRONT ENGINE MOUNTING BRACKET

a.
C138674

Remove the 3 bolts and mounting bracket.


Hide 12325A 9.REMOVE ENGINE MOUNTING BRACKET LH

a.
C138675

Remove the 3 bolts and mounting bracket LH.


Hide 30500 10.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

a.
C127819

Remove the flywheel housing under cover.


b.

Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.


c.
C127820

Remove the 4 lower side mounting bolts.


d.
C127822

Remove the 5 upper side mounting bolts.


e.

Separate and remove the automatic transaxle.


Hide 35013 11.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

a.
C140267

Remove the ATF dipstick.


b.

Remove the bolt and oil filler tube.


Hide 33823 12.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

a.
C140268

Remove the 2 bolts and cable bracket.


Hide 32000 13.REMOVE TORQUE CONVERTER ASSEMBLY