Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292111 AUTOMATIC TRANSAXLE SYSTEM D

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the items below are satisfied:

i.

Battery positive voltage is 11 V or more


ii.

Throttle valve is fully closed


iii.

Transaxle is in the P or N position


iv.

A/C is OFF



b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch on (IG).


e.

Enter the following menus: Powertrain / ECT / Check Mode.


f.
A076900E69
0.292,0.74 0.521,0.938 0.229,0.198 10 false ON 0.271,1.573 0.563,1.771 0.292,0.198 10 false OFF 2.01,0.427 2.854,0.625 0.844,0.198 10 false 0.13 seconds 0.385,1.823 1.229,2.021 0.844,0.198 10 false 0.13 seconds

Change the ECM to check mode. Make sure that the MIL flashes as shown in the illustration.

NOTICE:

All DTCs and freeze frame data recorded will be erased if: 1) the intelligent tester is used to change the TCM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from on (IG) to on (ACC) or off.

Before entering check mode, make notes of any DTCs and freeze frame data that are present.



g.

Start the engine. The MIL should turn off after the engine starts.


h.

Perform "MONITOR DRIVE PATTERN" for the ECT test (See page Drivetrain>U660E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN).

(Or, duplicate the conditions of the malfunction described by the customer.)


i.

After duplicating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.